No results were found for the filter!
Submergible bilge pump RULE
Powerful submersible pump from RULE. The pump is made of sturdy plastic and is ideal for smaller boats due to its light and compact nature. The motor is fully enclosed and runs very quietly. The shafts can not rust and are specially...
from €35.90
Art.-Nr.: 1430...
Bilge pump RULE MATE
The proven automatic bilge pump, from US manufacturer RULE. Plastic housing with easily removable sieve baseplate. Quiet and fully encapsulated motor, stainless axis. Can be used as an automatic pump: Type RULE-MATE (RM) is controlled...
from €129.00
Art.-Nr.: 1430...
Bilge pump RULE AUTOMATIC
The proven bilgepump from the US manufacturer RULE. Plastic housing with easily removable sieve baseplate. Quiet-running and fully encapsulated motor. Also made as an automatic pump: Type: RULE-AUTOMATIC (RA) works through an automatic...
from €135.00
Art.-Nr.: 1430...
RULE LO-PRO Submersible Bilge Pump LP900D / LP900S
Flat, powerful bilge pump for tight spaces with freely adjustable hose outlet (vertical/horizontal) for 3 different hose diameters (19, 25 and 28 mm). All hose nozzles have lip check valves, the motor unit is removable for cleaning,...
from €69.00
Art.-Nr.: 1430...
Bilge pump MARCO
High-performance bilge pump, available in various sizes for 12V or 24V systems. Discharge head up to 3 m. The snap-off plastic housing can be opened easily for maintenance and cleaning. Low power requirements. Stainless-steel shaft with...
from €37.95
Art.-Nr.: 1321...
Bilge pump WHALE ORCA
Submersible bilgepump with strong permanent magnet motor and special shaft seals. The outer cover can be removed for inspection. Shaft of rust-free steel. These pumps are only partially protected against dry-running, so the installation...
from €39.90
Art.-Nr.: 1436...
Electric diaphragm pump WHALE GULPER 220
WHALE GULPER type 220: Electric membrane pump for pumping the bilge or emptying the head or holding tank (grey water pump). Self-priming. Suction lift max. 3 m, dicharge head max. 3 m, combined suction lift / discharge head max. 4m....
from €198.00
Art.-Nr.: 1437...
Electric diaphragm pump WHALE GULPER 320
WHALE GULPER type 320: Electric membrane pump for pumping the bilge or pumping out the head or holding tank (grey water pump). Self-priming. Suction lift max. 3m, dicharge head max. 3 m, combined suction lift / discharge head max. 4m....
€269.00
Art.-Nr.: 1437...
Small bilge pump WHALE SUPERSUB
Extremely low-profile, submersible pump with good power, by the renowned pump manufacturer WHALE , which can also be placed between frames and floor boards. Removable sieve, outflow hose adjustable from horizontal to vertical. Article...
from €49.90
Art.-Nr.: 1441...
Small bilge pump WHALE SUPERSUB-SMART
Extremely low-profile, submersible pump with good power, by the renowned pump manufacturer WHALE , which can also be placed between frames and floor boards. Equipped with a built in, maintenance free 'electric field sensor' as integrated...
from €94.90
Art.-Nr.: 1441...
Impeller pump JABSCO UTILITY-PUPPY 2000
Powerful impeller pump with bronze pump head and impeller made of nitrile rubber (oil-resistant), dry self-priming up to 1.20 m. Developed for pumping bilge water. Dry-running protection up to 20 minutes. Capacity 32 l/min at 3 m (0.3...
€439.00
Art.-Nr.: 1805...
Bilge pump FLOJET QUAD 4125
High-performance bilgepump without pressure switch, laid out as a four-chamber membrane pump. The pump is self-priming to 2 m, can run dry safely and runs extremely quietly, thanks to rubber mountings. Attachment: plug with 19 mm hose...
€279.00
Art.-Nr.: 4627...
Top seller