Antennas, Sockets & Accessories


Close window
Antennas, Sockets & Accessories


1 From 3
No results were found for the filter!
1700_03 Isolator (POM)
With this isolator backstays and shrouds can be made into effective radio antennas. The isolator must be installed in two intertwined wire eyes. The cleanly milled grooves thereby allow the wires a large bending radius, through which...
from €51.90
Art.-Nr.: 1700...
1707_03 Insulator NORSEMAN
Isolator for installation on antenna wires or stays which are used for antennas. Lloyd Register qualified. Skilled processing means the breaking load of the appropriate wires is not reduced. Approved Norseman terminals on both sides.
from €296.00
Art.-Nr.: 1707...
2215_01 KOAX cable
KOAX cable for VHF, D=10mm.
from €1.95
Art.-Nr.: 2215...
3937_11 Charging cables 12V for ICOM handheld VHFs
Charging cables for ICOM VHF handhelds. With these cables the batteries may be charged from the 12V power supply on board. ICOM CP-23L for handhelds ICOM M35, M71, M87, M91, GM160E. ICOM CP-25H for handhelds ICOM M73, M93.
€29.90
Art.-Nr.: 3937...
3938_12 External VHF speaker ICOM SP-24E
To connect to a stationary or mobile vhf kept below deck. Input 7 W max., impedance 4 Ohm., 4,5 m cable with 3,5 mm phone jack. Case measurements L x H x W: 110 x 110 x 85 mm, with plastic mounting bracket, splash water protected.
€69.00
Art.-Nr.: 3938...
3940_01 VHF long fiberglass antenna CX
Fiberglass VHF rod antenna CX, 156-163MHz. 3 dB gain. Length overall 130 cm, antenna 120 cm, weight 0.5 kg. With chromed union nut 1"BSP and PL-socket. For mounting with a standard deck or rail fitting with 1"x14TPI threads an additional...
€99.90
Art.-Nr.: 3940...
3940_02 Pivot hinge antenna socket polyamide
Tiltable socket for VHF or GPS antennas with standard thread 1"x14TPI. For deck or bulkhead mounting. Made from white polyamide PA plastic.
€14.90
Art.-Nr.: 3940...
3940_03 VHF stainless whip antenna
Light, high-performance, stainless steel VHF whip antenna 156-163 Mhz, ideal for mast mounting on sailboats. PL socket for cord attachment. Length 1,0m, weight with bracket 0,6 kg. Comes with stainless mast bracket. Comes without antenna...
€49.90
Art.-Nr.: 3940...
3940_04 Adapter for CX antenna to 1"x14 TPI socket
Stainless steel adaptor to fit a CX-antenna to a standard antenna deck fitting. One side with 1" BSP outer thread for the antenna, the inner threads on the opposite side fit all antenna sockets with 1"x14TPI threads. The tube has a slot...
€39.90
Art.-Nr.: 3940...
3940_05 Pivot hinge antenna socket stainless steel
Tiltable socket for VHF or GPS antennas with standard thread 1"x14TPI. For deck or bulkhead mounting. Sturdy version made from stainless steel A4.
€43.50
Art.-Nr.: 3940...
3940_06 Fixed sockets 1" x 14TPI for antenna / GPS /...
Different types of antenna sockets. All sockets are suitable for VHF or GPS antennas or active radar target enhancer with standard theads 1" x 14 TPI. Available versions: - GLOMEX long, stainless steel - standard long, stainless steel -...
from €9.90
Art.-Nr.: 3940...
3940_07 Plastic antenna socket with rail bracket
Antenna mounts made from white polyamide (PA) for the installation of GPS and VHF antennas on horizontal rails of 22mm - 25mm. Standard antenna thread: 1" x 14 TPI.
€19.90
Art.-Nr.: 3940...
1 From 3